top of page

Sometimes 8 feet is just not enough, and if you are like me, mounting that Vectra driver and being limited to where you can put it can be a huge disappointment. The other option being you have the perfect spot to place your driver but now you are limited to where you can mount your pump. Again, 8 feet, sometimes, is just not enough.

Made for reefers, by a reefer.


Plug & Play, installs in just a few minutes time as it mounts inline with your stock driver and dryside pump cable. A small Philips Head screwdriver is all that is needed.

Instructions:

Be sure to unplug the mains power from the driver before proceeding,
Gently pinch and remove the control dial from the face of the Vectra driver unit,
Remove three screws from the backside of the driver case,
Remove the rear casing,
Unplug the larger beige connector for the stock cable,
Plug the extension cable inline of the driver header connection and stock cable,
Reassemble the driver housing and correctly orient and push the control dial back on,
Enjoy!

Highlights of this cable:

Starting at lengths of 4 feet; also available in 6', 8', 10', 12'
6.1mm outside diameter cable offers similar flexibility to the stock cable
Shielded 5 conductor, 22AWG wire crimped to compatible plug ends for a professional appearance.

 

This cable is compatible with Vectra S/M/L as well as Vortech MP10/40wQD pumps.

 

<br><br>Vectra Pump or Driver unit not included

Extension for Ecotech Marine Vectra pumps

PriceFrom $41.90
  • BE AWARE, THIS CABLE IS NOT WATER RESISTANT IN IT'S ORIGINAL FORM AND SHOULD NOT BE INSTALLED IN A PLACE WHERE IT MAY COME IN CONTACT WITH WATER! We recommend that you tightly wrap the connecting parts in electrical tape and/or heat shrink tubing if it may be splashed on by water.

bottom of page